Watch the tutorial video below for further help.

Inline Sediment & Carbon Filter Installation Guide

Step-by-Step Installation Process

1. Turn Off Water Supply & Power

   Shut off the water supply and disconnect power to the RO system.

2. Relieve Pressure

   Open the RO faucet to release any water pressure in the lines.

3. Locate Old Inline Filters

   Identify the inline sediment filter and inline carbon filter in your RO system.

4. Disconnect Tubes from Old Filters

   • Push the collet ring on the push-fit connector inward.

   • Gently pull the tube out from both ends of the old filter.

5. Remove Old Filters

   Take out the old filters and discard them properly.

6. Check Flow Direction

   Each new filter has an arrow indicating water flow. Make sure you align it correctly.

7. Connect Tubes to New Filters

   • Insert the tube firmly into the push-fit connector until it locks.

   • Slightly pull back to ensure it’s secured.

8. Double-Check Connections

   Confirm that both filters are installed in the correct sequence:

   • Sediment filter first

   • Carbon filter next

9. Turn On Water Supply

   Slowly turn on water and check for leaks at the connections.

10. Flush the Filters

    Allow water to flow for 10–15 minutes to remove any loose carbon particles before drinking.

​

Important Note

Our inline sediment and carbon filters are brand-new, quality-tested, and 100% defect-free. If your RO system does not work properly after installation, possible reasons include:

• Incorrect filter flow direction

• Loose or improperly inserted tubes in push-fit connectors

• Clogged or exhausted RO membrane (if TDS remains high)

• Low input water pressure

• Other faulty components like pump or flow restrictor

Tutorial Video: