Step-by-Step Installation Process

Watch the tutorial video below for further help.

 

1. Turn Off Water Supply & Power

   Shut off the water supply and disconnect the power to your RO system.

2. Relieve Pressure

   Open the faucet to release any pressure inside the system.

3. Locate the Membrane Housing

   Find the cylindrical membrane housing, usually on the top part of your RO system.

4. Open the Housing Cap

   Use a wrench if needed. Be careful not to damage the O-rings.

5. Remove the Old Membrane

   Pull out the old RO membrane using pliers if necessary. Dispose of it properly.

6. Clean the Housing

   Rinse the inside of the housing to remove dirt and debris.

7. Insert the New RO Membrane

   Push the new membrane inside firmly until it is seated correctly. Ensure the end with two O-rings goes in first.

8. Close the Housing Cap

   Tighten securely but do not overtighten to avoid cracks.

9. Reconnect and Check for Leaks

   Turn the water supply back on, reconnect power, and inspect for leaks.

10. Flush the System

    Allow water to run through the system for at least 30 minutes to flush out any preservatives before drinking.

 

 

Important Note

 

Our RO membranes are brand-new, factory-tested, and 100% defect-free. If your system does not perform as expected, common reasons include:

 

• Incorrect installation (membrane not fully seated)

• Clogged pre-filters or post-filters

• Low water pressure or faulty pump

• Damaged flow restrictor or check valve

• High TDS or very hard water requiring additional treatment

• Worn-out or damaged O-rings causing leaks